During an inspection, it was found that data racks were not properly grounded. To pass the
inspection and address a growing concern to protect data cabling and equipment, a technician
must make sure all racks are properly grounded.
Which of the following tools should the technician use to verify this has been completed?
a. Multimeter
b. Cable tester
c. Tone generator
d. Voltmeter

A Multimeter which is an electrical device that can be operated by hand and can be used to measure voltage, current and resistance in a circuit is the best tool which the technician must use to make sure all racks are properly grounded.

Answer Link

haseebee12 haseebee12 · Answer 2 · 2020-01-29T06:23:34+01:00

Answer:

During an inspection, it was found that data racks were not properly grounded. To pass the inspection and address a growing concern to protect data cabling and equipment, a technician must make sure all racks are properly grounded. The following tools the technician should use to verify this has been completed:

a. Multimeter

Explanation:

The option a is correct as the multimeter is used for ground bond test which is also known as ground continuity test.
The option b is not correct as the cable tester is used to check the connectivity or strength of a wire.
The option c is incorrect as tone generator is used for audio devices as it convert the electrical signal in audio signal.
The option d is also incorrect as it is not sufficient to check the ground. As it is check the potential difference between two points.